Chemical Anchor Hole Cleaning Kit 10, 12, 14mm

The three nozzle sizes you need to clean a drilled hole before setting a chemical anchor. Printed for DeWalt wet/dry vacuums with a 35mm hose fitting, the 10, 12 and 14mm sizes match the holes for M8, M10 and M12 chemical anchor studs, the sizes used in most structural fixing in Australia.

Ramset and Hilti both list hole cleaning as a mandatory installation step. If resin goes onto drilling dust it bonds to the dust rather than the concrete, and the anchor can pull out well under its rated load. Both manufacturers accept a vacuum as a way to remove the dust.

What is in the kit

• 10mm nozzle for an M8 chemical anchor stud for DeWalt 35mm vacuums
• 12mm nozzle for an M10 chemical anchor stud for DeWalt 35mm vacuums
• 14mm nozzle for an M12 chemical anchor stud for DeWalt 35mm vacuums
• All three printed to fit DeWalt wet/dry vacuums with a 35mm hose fitting

Free standard shipping within Australia.

Made to order. Printed for your order and dispatched within 1 to 3 business days via Australia Post, Australia wide.

See the full hole size and anchor chart, with manufacturer data sheets.

Prolonged or heavy use may cause premature wear on your vacuum. Use at your own discretion. Industrial Printworks is not affiliated with, authorised by or endorsed by DeWalt or Stanley Black & Decker. DeWalt is trademarks of their respective owners and are referenced only to indicate compatibility.